2020 Toyota Highlander Air Filter in Murray, UT

The 2020 Toyota Highlander engine air filter sits in a rectangular airbox inside the engine bay, typically on the driver’s side ahead of the intake tube.

This airbox opens with simple clips or screws for quick inspection. During service in Murray, our technicians also check the intake ducting and seals, which can be stressed by winter road debris and dust along the Wasatch Front. Proper seating prevents unfiltered air from reaching the 3.5L V6 intake.

• Engine bay airbox with snap clips or screws
• Located near the intake tube on the driver’s side
• Housing and seal inspection helps maintain MAF sensor accuracy

The engine air filter protects the 3.5L V6’s combustion intake, while the cabin air filter cleans the HVAC air passengers breathe.

On the Highlander, the engine filter sits in the under‑hood airbox; the cabin filter is typically mounted behind the glove box. In Utah, road dust and seasonal pollen can load both filters faster, so inspections during routine service in Murray are smart.

• Engine filter = intake air to the V6; affects performance and fuel economy
• Cabin filter = HVAC air; reduces dust, pollen, and odors
• Different locations and media; both are serviceable in minutes

Common signs include reduced power, lower fuel economy, and a rough idle for the engine filter; weak airflow and musty odors point to a clogged cabin filter.

If you drive in Sandy, West Jordan, or up the canyon roads, dust can accumulate quickly. Our Murray team checks both filters and the intake path to keep your Highlander’s 3.5L V6 breathing clean and the HVAC flowing freely.

• Engine: sluggish acceleration, poorer MPG, possible check engine light
• Cabin: weak fan output, haze on glass, odors when A/C starts
• Visual inspection can confirm debris or darkened media

Yes—engine filters are often DIY-friendly; dealer service adds OEM-spec parts plus intake and MAF checks that protect your Highlander’s V6.

The cabin filter typically sits behind the glove box and may require trim disengagement. At Larry H. Miller Toyota Murray, we install Toyota Genuine Parts and verify housing seals—useful in Utah’s dusty climate.

• DIY possible for engine filter with basic tools
• Cabin filter access behind glove box can be trickier
• Dealer includes fitment verification and sensor-safe handling

The 2020 Toyota Highlander cabin air filter is typically located behind the glove box within the HVAC case.

Dropping the glove box provides access to the filter door. In the Salt Lake Valley, pollen peaks and winter inversion particulates make a clean cabin filter especially helpful for clear airflow and odor control.

• Behind glove box; access panel on the HVAC housing
• Check airflow direction arrows when installing
• Replace more frequently if driving in dusty conditions

Yes—Larry H. Miller Toyota Murray installs Toyota Genuine Parts engine and cabin air filters on the 2020 Toyota Highlander.

OEM filters match Toyota engineering for the 3.5L V6 intake and the HVAC system. Proper fit helps maintain performance, fuel economy, and HVAC airflow for driving in Murray, Millcreek, and beyond.

• Toyota Genuine Parts for correct fit and filtration
• Engine intake and MAF sensor area visually checked
• Backed by Toyota parts warranty terms

Follow the Toyota maintenance schedule in your owner’s manual for the 2020 Toyota Highlander’s engine air filter interval.

Because Utah driving often includes dust, construction zones, and winter road grit, an earlier inspection can be prudent. Our Murray service team can check restriction and condition during any visit and advise based on your routes.

• Use the official Toyota schedule as the baseline
• Shorten intervals if driving in dust or heavy pollen
• Quick inspections available during oil or tire service

Use the 2020 Toyota Highlander owner’s manual to follow Toyota’s official cabin air filter interval.

Local factors like spring pollen in the Salt Lake Valley and wildfire smoke can load the cabin filter sooner. If airflow weakens or odors appear, schedule a quick check in Murray and we’ll assess condition and replacement timing.

• Baseline interval per Toyota’s maintenance guide
• Accelerated replacement in dusty or high‑pollen seasons
• Inspection included during HVAC or routine service

Our air filter service for the 2020 Toyota Highlander is focused on clean airflow and correct fitment. We start with an engine air filter inspection and replacement as needed, then inspect and replace the cabin air filter if it’s loaded or odorous. The technician checks the intake housing, clamps, and seals to avoid unmetered air, and performs a visual look at the MAF sensor area without disturbing it. Service includes proper filter orientation and sealing. Toyota parts are backed by Toyota’s parts warranty terms. If you’re ready to get this done, use our quick links to schedule service and review current service specials.

The 2020 Toyota Highlander uses an engine air filter sized for its 3.5L V6 (295 hp, 263 lb‑ft) and a dedicated cabin filter for the HVAC system. Toyota recommends following the owner’s manual for both engine and cabin filter replacement intervals. We install Toyota Genuine Parts to match OEM specifications, which helps preserve intake sealing and HVAC airflow. If your driving includes dusty construction zones, canyon byways, or winter road grit, inspections between scheduled services are sensible. Bring your 2020 Toyota Highlander to Larry H. Miller Toyota Murray in Murray for OEM-spec filter service — schedule service.

Larry H. Miller Toyota Murray serves the Salt Lake Valley and Greater Salt Lake City metro area—including Murray, Salt Lake City, Sandy, West Jordan, South Jordan, Millcreek, Holladay, and Taylorsville. Local conditions matter: Wasatch Front dust, seasonal pollen, and winter road debris can shorten filter life on a 2020 Toyota Highlander. With decades of continuous operation since 1979 and a team of factory-trained technicians, we provide consistent, Toyota-guided inspections that keep airflow within spec. Visit our modern service center at 5650 South State Street, Murray, UT 84107 for prompt check-in, or tap to schedule service and see service specials before you arrive. Clear directions and fast communication make upkeep straightforward.