2016 Toyota Land Cruiser Air Filter

It sits in the engine bay inside the airbox on the passenger side, upstream of the 5.7L V8 intake tube.

This placement allows the filter to clean incoming air before it reaches the Land Cruiser’s 381‑hp V8. In our Murray service bays, technicians check the housing clips, seal, and intake snorkel to ensure no unmetered air bypasses the filter. If you drive dusty frontage roads around the Salt Lake Valley, the airbox can accumulate debris more quickly.

• Passenger-side airbox with quick-release clips
• Upstream of the mass airflow (MAF) sensor
• Seating surface requires a proper gasket seal

The engine air filter protects the V8’s intake from dirt, while the cabin air filter cleans air entering the HVAC system for passengers.

On the Land Cruiser, the engine filter supports performance and fuel economy by keeping contaminants out of the 5.7L V8. The cabin filter, typically behind the glove box, traps dust and pollen common along the Wasatch Front. At Larry H. Miller Toyota Murray, both filters are inspected during service for condition and sealing.

• Engine filter = combustion air protection
• Cabin filter = HVAC and passenger air quality
• Different locations, sizes, and media

Engine: reduced power, lower MPG, or rough idle; Cabin: weak airflow, increased fogging, or a musty odor.

In Northern Utah, dust and seasonal pollen can load filters faster, especially with mountain or construction-zone driving. If your Land Cruiser feels sluggish on I‑15 climbs or the blower struggles to clear the windshield, it’s time for an inspection. Our Murray team checks filter media and the housing for debris and proper sealing.

• Engine symptoms: hesitation, throttle lag, darker filter media
• Cabin symptoms: reduced vent flow, odor, visible dust
• Visual check: tears, warped edges, or damp spots

Yes—engine filters are DIY-friendly; the cabin filter typically requires glove box removal and careful reassembly.

The Land Cruiser’s airbox uses clips that most owners can manage. The cabin filter sits behind the glove box and can involve trim manipulation; incorrect seating can cause noises or bypass. Dealer service adds an intake/MAF inspection and confirmation that the filter seals properly—important in Utah’s dusty conditions.

• DIY possible: engine air filter with basic tools
• Cabin filter: glove box area access and correct orientation
• Dealer adds MAF/intake checks and OEM-spec fitment

Yes—Toyota Genuine engine and cabin filters are available for the 2016 Toyota Land Cruiser at our Murray dealership.

OEM-spec filtration helps maintain proper airflow and sealing for the 5.7L V8 and the HVAC system. Our factory-trained Toyota technicians match the correct part specification and inspect the airbox, ducts, and MAF area for debris. This approach supports performance and cabin air quality across the Salt Lake Valley.

• OEM-spec media and dimensions for proper fit
• Installed by Toyota-trained technicians
• Airbox and ducting inspected for leaks and debris

Schedule online anytime using our service scheduler at the link: schedule service.

Use our quick online tool to choose a time that fits your day in Murray or the Greater Salt Lake City metro. You can also review current offers before booking. For convenience, add notes about engine or cabin filter concerns and we’ll be ready when you arrive.

• Online booking: schedule service
• Check offers: service specials
• Address: 5650 South State Street, Murray, UT 84107

Visit Larry H. Miller Toyota Murray at 5650 South State Street, Murray, UT 84107.

Our Toyota Service Center serves Murray, Salt Lake City, Sandy, West Jordan, South Jordan, Millcreek, Holladay, and Taylorsville. We inspect the glove box area, fit the correct filter orientation, and verify HVAC airflow. Book ahead online to minimize wait time.

• Central location near I‑15 and State Street
• Toyota-trained technicians and OEM-spec parts
• Online appointments: schedule service

Frequent dust, winter road grit, and spring pollen along the Wasatch Front can load both filters faster than in mild climates.

Construction zones, canyon drives, and lake-effect winds move fine particulates into the intake and HVAC system. The Land Cruiser’s large V8 draws significant airflow, so a partially loaded filter can be noticeable on uphill stretches. Our Murray team inspects filters and housings for debris and correct sealing.

• Dust and grit increase media loading
• Pollen seasons impact cabin air quality
• Periodic checks help maintain performance and airflow

It’s typically located behind the glove box in the HVAC intake area.

Access involves lowering or removing the glove box to reach the filter tray. In our Murray service center, technicians verify the airflow direction, seat the filter evenly, and confirm quiet operation of the blower door. This ensures proper filtration for drives around Salt Lake City and neighboring communities.

• Behind-glove-box access panel
• Filter orientation arrow must face airflow
• Tray fully latched to prevent noise or bypass

Our process for the 2016 Toyota Land Cruiser covers both engine and cabin filtration with attention to sealing and airflow. A Toyota-trained technician inspects the engine airbox, releases the clips, and evaluates the filter media for debris, tears, or moisture. If replacement is needed, we install an OEM-spec filter and confirm the gasket seats evenly around the airbox perimeter. Next, we visually check the intake ducting and mass airflow (MAF) sensor area for obstructions or loose connections. For the cabin filter, we access the glove box area, remove the filter tray, verify the airflow direction arrow, and install the new filter with even seating. After reassembly, HVAC airflow is tested at multiple fan speeds. To plan your visit, review current offers on our service specials page and schedule service online.

The 2016 Toyota Land Cruiser’s 5.7L V8 (engine code 8VNAG5.7) relies on a properly sealed engine air filter to meter clean intake air, supporting its 381 horsepower and 401 lb‑ft of torque. The cabin air filter safeguards HVAC performance and interior air quality by trapping dust and pollen common to the Salt Lake Valley. Always use filters built to Toyota OEM specifications to ensure correct media density, dimensions, and housing fit—this helps prevent unmetered air from bypassing the MAF sensor and maintains stable idle quality. If you see excessive debris in the airbox or notice reduced cabin airflow, plan an inspection. Bring your 2016 Toyota Land Cruiser to Larry H. Miller Toyota Murray in Murray for OEM-spec filter service — schedule service.

We serve the Salt Lake Valley and Greater Salt Lake City metro area—including Murray, Salt Lake City, Sandy, West Jordan, South Jordan, Millcreek, Holladay, and Taylorsville—with factory-authorized air filter care for the 2016 Toyota Land Cruiser. Local conditions such as construction dust, canyon winds, winter road grit, and spring pollen can load engine and cabin filters more quickly, affecting throttle response and HVAC airflow. Our modern facility and Toyota-trained staff inspect filter housings, seals, and ducts so clean air reaches both the 5.7L V8 and your cabin. Plan your visit, review current offers on our service specials, and schedule service. For directions, find us at 5650 South State Street, Murray, UT 84107.