2010 Toyota Highlander Air Filter

The engine air filter sits in a rectangular airbox in the engine bay, typically on the driver-side fender near the intake snorkel.

This airbox feeds the 3.5L V6 intake on your 2010 Toyota Highlander and is secured with clips or screws for quick access. Replacing a dirty filter helps maintain airflow, horsepower, and throttle response across Murray and Salt Lake City driving. If you prefer professional service, our Toyota technicians can inspect the airbox housing and seals during replacement.

• Rectangular airbox with clips/screws
• Driver-side fender area in most layouts
• Feeds the V6 intake via the snorkel/duct

The cabin air filter is located behind the glove box in the HVAC intake area.

On the 2010 Toyota Highlander, you’ll typically lower or unhook the glove box to access the filter tray. This filter scrubs pollen, dust, and debris from outside air before it enters the cabin. If you’d like help, our team in Murray can replace it and check the blower door and tray alignment for a proper seal.

• Behind glove box access panel/tray
• Filters air before it enters vents
• Glove box may need to be lowered

The engine filter protects the 3.5L V6 intake from dirt, while the cabin filter cleans the HVAC air you breathe inside the vehicle.

For your 2010 Toyota Highlander, the engine air filter supports combustion, power, and fuel economy; the cabin filter improves interior air quality and HVAC performance. Both should be inspected regularly, especially with mixed city, canyon, and freeway driving around the Salt Lake Valley. We install OEM-spec filters to maintain fit, filtration, and airflow.

• Engine: intake protection and performance
• Cabin: interior air quality and airflow
• Different locations, different filter media

Common signs include reduced power, worse fuel economy, rough idle (engine), weak HVAC airflow, and musty odors (cabin).

On the 2010 Toyota Highlander, a restricted engine filter limits intake airflow to the 3.5L V6, while a loaded cabin filter chokes ventilation. Utahs stop-and-go traffic and dusty construction zones can accelerate loading. If you notice these symptoms in Murray or Salt Lake City, book an inspection so we can confirm the cause and restore performance.

• Engine: hesitation, low power, higher fuel use
• Cabin: weak vent flow, odors, hazy defrost
• Visual: dark, debris-filled filter media

Yesthe engine filter is typically DIY-friendly, while the cabin filter is doable but may require glove box removal.

Many owners swap the 2010 Toyota Highlander engine filter by unclipping the airbox. The cabin filter sits behind the glove box and needs careful access to avoid breaking stops or tabs. Dealer service adds an intake housing check and a visual MAF inspection to catch issues early. If you prefer, you can schedule service online.

• DIY engine filter: airbox clips/screws
• DIY cabin filter: glove box lowered
• Dealer adds intake/MAF checks

Yeswe install Toyota OEM-spec engine and cabin filters that meet factory filtration and fit standards.

Using OEM-spec parts on your 2010 Toyota Highlander helps maintain designed airflow, sealing, and filtration performance. Our factory-trained team in Murray follows Toyota procedures and disposes of old filters responsibly. Ask us to show the old and new filters during your visit for transparency.

• OEM-spec fit and media quality
• Proper sealing in airbox and HVAC tray
• Documented installation by Toyota technicians

Book online at https://www.larryhmillertoyota.com/service/appointment-form.htm in a few clicks.

Choose a time that fits your day, then note “engine air filter” or “cabin air filter” for your 2010 Toyota Highlander. You can also review current service specials before confirming. Were located at 5650 South State Street, Murray, UT 84107, serving the Greater Salt Lake City metro.

• Online scheduler with preferred times
• Add notes for engine or cabin filter
• Check service specials before you book

Yeswe perform a visual MAF and intake housing check during air filter service.

For the 2010 Toyota Highlander, our technicians visually inspect the mass airflow (MAF) sensor area and the airbox seals while replacing the engine filter. This helps identify leaks, debris, or contamination that can affect driveability. If we see buildup, well recommend the appropriate next step.

• Visual MAF and duct inspection
• Airbox lid/seal fit verification
• Recommendations if contamination is found

Our air filter service for the 2010 Toyota Highlander covers both airflow protection and cabin comfort. A technician confirms the engine air filter condition, replaces it if needed, and checks the airbox lid, seals, and ducts for proper fit. We then access the cabin filter behind the glove box, inspect the tray and blower door, and install an OEM-spec filter to restore HVAC airflow and interior air quality. A visual MAF and intake check is included to spot leaks or contamination early. For added value, review our current service specials and schedule service at your convenience.

Larry H. Miller Toyota Murray serves the Salt Lake Valley and Greater Salt Lake City metro areaincluding Murray, Salt Lake City, Sandy, West Jordan, South Jordan, Millcreek, Holladay, and Taylorsville. Urban construction dust, canyon drives, and seasonal debris can load filters faster on the 2010 Toyota Highlander, reducing engine performance and HVAC efficiency. Our factory-trained, OEM-certified technicians follow Toyota procedures and use OEM-spec parts to maintain designed airflow. Since opening in 1979, our dealership has focused on transparent inspections and clear next steps. Visit us at 5650 South State Street, Murray, UT 84107, or schedule your appointment online for convenient drop-off and pick-up.

Your 2010 Toyota Highlander uses an engine air filter sized for the 3.5L V6 (270 hp) intake and a separate cabin filter that fits the HVAC tray behind the glove box. Toyota recommends following the maintenance guide for inspection and replacement intervals; heavy dust, frequent short trips, or stop-and-go driving may require more frequent service. We install OEM-spec Toyota filters engineered for correct fit, seal compression, and filtration media, helping protect the intake tract and improve cabin air quality. If youve noticed reduced power, rising fuel use, weak vent airflow, or musty odors, its time to inspect. Bring your 2010 Toyota Highlander to Larry H. Miller Toyota Murray in Murray for OEM-spec filter serviceschedule service.